Ay Wood project

Plywood cart

A post on the EurekaZone forum on SMC got me to thinking about an old project, a modification of my current plywood cart to make it more functional. This is the beginning of the design. It has a torsion box table that can be either horizontal for unloading from the truck and loading on to the PBB, or nearly vertical for moving around the shop and loading into my plywood storage area.




After some thinking and tinkering, I have come up with this rough draft. The leg will probably go in the middle, but could put one on each end. You lift the table a little and push the leg in to lower the table. Works kind of like an aircraft landing gear scissor, which goes past dead straight to lock in the over extended (gear down) state.




I think that this is the final design, at least until I begin to build.